SIMPLIS Model

youshang

我現在給的PCB and Package .sp檔是用最簡單的方式只有出Port,沒有把其它電容電阻電感掛在PCB上面

所以若只有放PCB 如附件2~3 and SIMPLIS Model如附件1是可以Work的,如藍色框框

但是把Package如附件4~5加入進來會有如下錯誤的訊息在幫忙解析是哪個環節出錯,如綠色框框

<<<<<<<< Error Message ID: 5007 >>>>>>>>

The following variable(s) cannot

be uniquely solved:

I(X$U8.R#PIN_1), I(X$U8.R#PIN_2),

I(X$U8.R#PIN_3), I(X$U8.R#PIN_4),

I(X$U8.R#PIN_5), I(X$U8.R#PIN_6),

I(X$U8.R#PIN_7), I(X$U8.R#PIN_8),

I(X$U8.R#PIN_9), I(X$U8.R#PIN_10),

I(X$U8.R#PIN_11), I(X$U8.R#PIN_12),

I(X$U8.R#PIN_13), I(X$U8.R#PIN_14),

I(X$U8.R#PIN_15), I(X$U8.R#PIN_16),

I(X$U8.R#PIN_17), I(X$U8.R#PIN_18),

I(X$U8.R#PIN_19), I(X$U8.R#PIN_20),

I(X$U8.R#PIN_21), I(X$U8.R#PIN_22),

I(X$U8.R#PIN_23), I(X$U8.R#PIN_24),

I(X$U8.R#PIN_25), I(X$U8.R#PIN_26),

I(X$U8.R#PIN_27), I(X$U8.R#PIN_28),

I(X$U8.R#PIN_29), I(X$U8.R#PIN_30),

I(X$U8.R#PIN_31), I(X$U8.R#PIN_32),

I(X$U8.R#PIN_33) ...



Origin(s) of the error usually can be traced

to a shorted voltage source, an open-circuited

current source, a loop made up of only voltage

sources and zero-ohm resistances, or a cutset

made up of only current sources.



In this context, a voltage/current source can

be an independent voltage/current source or a

controlled voltage/current source.

等這個OK解決後,在慢慢將之前複雜化的東西如電容電阻電感掛在PCB上面加入進來跑Co-SIM


原廠一開始協助調整SP檔之後，有跟客戶提到是內部的元件太多造成問題，在此情況下，必須客戶去調整內部元件；